Seat Alhambra Key Problems

seat key cover's jumbo MPV range is among the top in its class when it comes to resales values. With a new generation model now on sale, it's better than ever.

There are a variety of reasons why the key fob may not perform as it should, including an unresponsive coin battery or damage to the receiver module or signal interference. This article will walk you through the steps to fix it.

Water Damage

If your seat alhambra keyfob is able to survive the wash cycle or a bath in the pool or ocean then it's probably equipped with an amazing waterproof chip but don't make this a habit as exposure to excessive water increases the risk of the key fob becoming damaged. If your key fob stops functioning after exposure to rain or clean tap water, take out the battery and wipe the electronic component using a towel. Dry it completely before replacing the battery. If the key fob was exposed to salty or soapy water and salty water, it is recommended you clean the chip with isopropyl or an electronic cleaner.

Faulty Receiver Module

If you've tried the battery of a button cell and the key fob isn't locked or unlocking, it is likely that the receiver module has found a fault. The good news is that this is a relatively simple and inexpensive repair, you can just disconnect the 12 volt battery for a few minutes (first remove the negative cable then press the horn button numerous times) to eliminate any remaining electric current, then reconnect it in reverse order e.g. Positive cable first followed by negative.

ESP Warning Light If the ESP warning light is flashing, this is normal and indicates that the car is traveling on terrains where the traction of the road surface and the tyres is not ideal like gravel, snow or lots of surface water. If the ESP light is always on, it indicates that there is a problem with the system. It is possible to identify the problem by using an iCarsoft i908 seat OBD code reader kit. It will give you a detailed fault description.

Dead Coin Battery

A dead coin battery is among the most common causes for the seat alhambra keys to cease to function. The key fob is powered by a small button-cell battery. Replace it with a new battery that has the same size, voltage and specifications as the original. If you're replacing the battery ensure that you remove all metal clips from the back of the key fob. Also, ensure that the contacts are free of corrosion.

If the key fob has been exposed to water, such as soapy or rain it is recommended to remove the battery and clean the electronic chip using isopropyl alcohol or an electronic cleaner prior to installing the new battery. The chip is sensitive to moisture and may be permanently damaged. If the key fob is still not working after replacing the battery, it may be necessary to replace the entire key fob.

Faulty Receiver Module

If your key fob stopped working after replacing the battery, but it did not function, or Seat Alhambra Key suddenly stopped working your receiver module might have experienced a malfunction. The receiver module receives radio frequency signals from your key fob's remote and transforms them into electrical signals that are then followed by other modules inside the car.

If the receiver module has a problem it will not be able to accept any commands from your remote key fob. In this situation the dealer will have to reprogram your key fob as well as install an additional receiver.

The key fob has been sealed with rubber to keep water from getting inside the electronic chip. If you immerse the key fob in salted or soapy ocean water, the chips inside could be damaged. If your key fob won't work, you could try cleaning the chip using isopropyl or an electronic cleaner.

If the keys have been linked, but the receiver module is faulty it is possible to restart all the electronics on board by disconnecting the 12-volt battery for a few minutes. Connect the battery in reverse (negative cable to positive first). This will reset the onboard electronic circuits and restore their functionality.

Electronic Chip Faulty

The key fob is outfitted with a small chip that transmits the signal from the key to the receiver module each time the key is used. If the signal isn't in line with the one the car has stored the immobilizer will turn off and prevent the vehicle from starting. If the key fob doesn't work and you aren't able to reprogram it, it could be because of an issue with the microchip.

The chip inside the key fob may have to be altered to make it work again. The best method to do this is to remove the key from its housing and then using a pin or needle to make contact with each of the retaining clips made of steel. You'll have to replace them when they're damaged or corrosion-prone. Make sure that any replacement batteries have the same voltage, size and specifications as the original.

Seat Alhambra is a popular and well-designed car, Seat Alhambra key can be troublesome due to certain parts or components. Some owners have reported problems with the auto climate control system. It is prone to malfunction and be stuck in a certain setting. The infotainment systems can also malfunction and freeze the screens.