Fiat 500 Replacement Key Fob

If your remote key fob has stopped functioning, it could be time to replace the battery. If you replace the battery and it doesn't work it could be a problem elsewhere.

United Locksmith specializes in the production of new fiat 500 key keys for classic automobiles. We have all the tools and components needed to provide this service.

Dead Coin Battery

A dead battery is the primary reason for your Fiat 500 keyfob not locking or unlocking the doors. The key fob has the battery of a coin-cell which will quickly drain if it is not frequently used. If your remote began to show signs of weakening like a loss of range or stopped working completely, the battery is probably dead.

Metal clips hold the battery in on the key fob. If the clips aren't tight enough, it can cause contact issues that will stop the remote from receiving power. Use a flathead screwdriver to open the retaining clips and then remove the old battery. Use a battery that has the same voltage, size and specification as the original.

The key fob can also be damaged or corroded through exposure to water. Even a short bath in warm, soapy water could cause damage to the chip. It is recommended to keep your key fob in a dry area.

Water Damage

If your key fob isn't operating properly, it may be due to water damage. Key fobs have rubber seals that protect them from being damaged by light rain or a splash of water, however it is crucial to keep your keys out of the pool, ocean, and washing machine!

The key fob is equipped with an electronic chip that transmits an alert to the immobilizer system of your car. The chip is what allows the 500 to lock and start. If it gets wet, it will no longer function.

Try cleaning the internal electronics of your key fob using isopropyl alcohol, or an electronic cleaner to see whether they're still functioning. It is best to replace a key fob in the event that it's submerged in salt water rather than attempting to fix it yourself.

A replacement fob might cost you a little bit however it's much less expensive than paying to have your Fiat 500 towed to a dealer and repaired there! You can also do it yourself with just a few steps. Just make sure you have the correct battery type before you attempt to open your key fob. This task is more straightforward than it appears, and you can find step-bystep instructions online for nearly every key fob for cars.

Faulty Chip

The chip inside the key fob is in direct communication with the immobiliser on your car to ensure that your vehicle will start only when the correct keys are used. If the chip is damaged, or corrupted it won't allow your car to start regardless of what you do.

Damage to the water or a dead cell battery are the most common causes of a faulty chip. Whatever the reason, it is best to delegate the work to a locksmith as they can replace the chip for you quickly and at a low cost.

If your key fob does not work after being exposed to water that is clean from the tap or rain then remove the battery. Clean the electronic component using a towel. If the key fob does not work, there's the possibility that it's an issue with the component and requires to be replaced.

Some people will go to their dealer when they are in need of a new Fiat 500 Replacement key Cost key fob, however this can be a very expensive option. United Locksmith is the best option for you if would like to have your Fiat keyfob fixed at a reasonable cost. We have the tools and experience needed to repair your Fiat fob in a timely and professional manner.

Faulty Receiver Module

Fiat key fobs send an alert up to 50 feet to the vehicle, which will open and close the doors (and start the vehicle for vehicles with automatic transmissions). There are several reasons why the fob might not function. These include a dead coin battery damaged by water buttons, worn out buttons or a problem with the receiver module, and signal interference or an electronic chip that is malfunctioning.

If the fob is in a pocket that has suffered a severe trauma, such as being dropped on hard floor or getting washed in the washing machine and it isn't capable of communicating with the car's Body Control Module (BCM). The BCM is a security system that can only accept signals from genuine original keys.

If this is the case, you must replace your fob. A professional locksmith is able to handle every aspect of the key replacement procedure as well as programming a new one for your 500. In fact, they can provide you with a replica key that functions exactly like your original fob (and costs only a fraction of the cost).